communication problem with ge RAEADER PRM5 EV1

AKA-Casi Rusco, Software-Facility Commander panel-M5/M3000, Cards-PXNplus, 8RP
Post Reply
mechatronix
Posts: 13
Joined: Sat May 07, 2011 6:39 am

communication problem with ge RAEADER PRM5 EV1

Post by mechatronix »

I HAVE THE READER CONNECTIVITY PROBLEM WITH GE READER PRM5 EV1 SF2F . I AM CONNECTING THIS READER TO PX-2000 THROUGH A JUNCTION BOX. IT IS NOT READING ANY MIFARE CARD AND GIVES A TRIPLE BEEP AT START UP. SHOULD I UPGRADE THE FIRMWARE OF PX-2000 CONNECTIN THIS READER OR THERE IS ANOTHER WAY TO SOLVE THIS PROBLEM. KINDLY REPLY ME IT'S URGENT.
mechatronix
Posts: 13
Joined: Sat May 07, 2011 6:39 am

Re: communication problem with ge RAEADER PRM5 EV1

Post by mechatronix »

how could i reprogram the reader i had reader model t-500 which was working with the px-2000. but i have to replace those readers with PRM EV1. BUT IT IS NOT COMMUNICATING what should i do?
Leo
Site Admin
Posts: 886
Joined: Thu Dec 11, 2008 7:52 am

Re: communication problem with ge RAEADER PRM5 EV1

Post by Leo »

The protocol for this reader is not F2F it is wiegand, if you are using a J-box the t-500 are using F2F.
So to get these reader to work with a px-2000 panel you will need a Wiegand to F2F converter also known as a HID interface.


check this post- http://www.thealarmtech.com/forum/viewt ... &hilit=hid
mechatronix
Posts: 13
Joined: Sat May 07, 2011 6:39 am

Re: communication problem with ge RAEADER PRM5 EV1

Post by mechatronix »

thanks but i have checked the data sheet of the reader the communication type of this reader is F/2f supervised plaese check the attachment.it is written at the back of the reader ''sF2F/o.c.''
Attachments
DS-EMEA-S1033000.pdf
this is the data sheet of the reader i am trying to communicate
(142.2 KiB) Downloaded 521 times
Last edited by mechatronix on Mon May 23, 2011 12:42 am, edited 1 time in total.
mechatronix
Posts: 13
Joined: Sat May 07, 2011 6:39 am

Re: communication problem with ge RAEADER PRM5 EV1

Post by mechatronix »

thanks but i have checked the data sheet of the reader the communication type of this reader is F/2f supervised plaese check the attachment.
mechatronix
Posts: 13
Joined: Sat May 07, 2011 6:39 am

Re: communication problem with ge RAEADER PRM5 EV1

Post by mechatronix »

what is the difference between weigand and f2f , why px 2000 is not supporting prm5 ev how would i know wether it is in weigand mode or f2f
Post Reply