Page 1 of 1
communication problem with ge RAEADER PRM5 EV1
Posted: Sat May 21, 2011 6:11 am
by mechatronix
I HAVE THE READER CONNECTIVITY PROBLEM WITH GE READER PRM5 EV1 SF2F . I AM CONNECTING THIS READER TO PX-2000 THROUGH A JUNCTION BOX. IT IS NOT READING ANY MIFARE CARD AND GIVES A TRIPLE BEEP AT START UP. SHOULD I UPGRADE THE FIRMWARE OF PX-2000 CONNECTIN THIS READER OR THERE IS ANOTHER WAY TO SOLVE THIS PROBLEM. KINDLY REPLY ME IT'S URGENT.
Re: communication problem with ge RAEADER PRM5 EV1
Posted: Sat May 21, 2011 6:40 am
by mechatronix
how could i reprogram the reader i had reader model t-500 which was working with the px-2000. but i have to replace those readers with PRM EV1. BUT IT IS NOT COMMUNICATING what should i do?
Re: communication problem with ge RAEADER PRM5 EV1
Posted: Sat May 21, 2011 9:07 am
by Leo
The protocol for this reader is not F2F it is wiegand, if you are using a J-box the t-500 are using F2F.
So to get these reader to work with a px-2000 panel you will need a Wiegand to F2F converter also known as a HID interface.
check this post-
http://www.thealarmtech.com/forum/viewt ... &hilit=hid
Re: communication problem with ge RAEADER PRM5 EV1
Posted: Mon May 23, 2011 12:30 am
by mechatronix
thanks but i have checked the data sheet of the reader the communication type of this reader is F/2f supervised plaese check the attachment.it is written at the back of the reader ''sF2F/o.c.''
Re: communication problem with ge RAEADER PRM5 EV1
Posted: Mon May 23, 2011 12:31 am
by mechatronix
thanks but i have checked the data sheet of the reader the communication type of this reader is F/2f supervised plaese check the attachment.
Re: communication problem with ge RAEADER PRM5 EV1
Posted: Mon May 23, 2011 7:18 am
by mechatronix
what is the difference between weigand and f2f , why px 2000 is not supporting prm5 ev how would i know wether it is in weigand mode or f2f