FCI 7100 reporting code for CID

Post Reply
rondparker
Posts: 37
Joined: Wed Apr 13, 2011 4:59 pm

FCI 7100 reporting code for CID

Post by rondparker »

My panel is set for option '6' which is the 4/2 transmission to the central station. I cannot find the option for CID. Can anyone help please?
Leo
Site Admin
Posts: 886
Joined: Thu Dec 11, 2008 7:52 am

Re: FCI 7100 reporting code for CID

Post by Leo »

main->config->dact->account options->comm format
in manual page 33
rondparker
Posts: 37
Joined: Wed Apr 13, 2011 4:59 pm

Re: FCI 7100 reporting code for CID

Post by rondparker »

I don't have the manual. I can get to the programming on the panel but do not have the 'option' number for CID. Right now it is '6' for 4/2 reporting. Can you help?
Thanks
pyrosucks
Posts: 106
Joined: Wed Feb 23, 2011 9:08 am

Re: FCI 7100 reporting code for CID

Post by pyrosucks »

FCI 7100 Install manual
Attachments
00-0447.pdf
(270.77 KiB) Downloaded 303 times
rondparker
Posts: 37
Joined: Wed Apr 13, 2011 4:59 pm

Re: FCI 7100 reporting code for CID

Post by rondparker »

I am very grateful. It helps me a lot. Thank you.
rondparker
Posts: 37
Joined: Wed Apr 13, 2011 4:59 pm

Re: FCI 7100 reporting code for CID

Post by rondparker »

Now that the Contact ID option has been successfully changed (it is number '2') in the DACT programming I am looking to find out what numbers FCI is sending for their modules.
I know from Firelite that they add '159' to the device ID of a module, so a pull station set to 12 would send a '171' to the central station.

My FCI 7100 sends a '223' for a module set to '150' - is there also a standard offset to add? Anyone know?
rondparker
Posts: 37
Joined: Wed Apr 13, 2011 4:59 pm

Re: FCI 7100 reporting code for CID

Post by rondparker »

Issue solved. Thank you. This panel does not send individual device numbers
Post Reply