actual devices are not shown in mapping menu

Post Reply
pooriyasms
Posts: 18
Joined: Sat Jun 09, 2012 11:55 pm

actual devices are not shown in mapping menu

Post by pooriyasms »

Dear friends,

When I connect to the panel and want to check the devices on the loop via mapping menu the devices are not shown in the mapping menu!
actual devices in loop statistics are all 0 (zero) and expected devices are true!
what should I do?
Thank you all in advance.
Attachments
Problem with mapping!
Problem with mapping!
Leo
Site Admin
Posts: 887
Joined: Thu Dec 11, 2008 7:52 am

Re: actual devices are not shown in mapping menu

Post by Leo »

this is a common problem, it maybe as simple as a smoke detector not snapped in all the way.
open the slc loop with only a few devices and try and map it.
when the troubled wiring is not in the slc loop it will map
pooriyasms
Posts: 18
Joined: Sat Jun 09, 2012 11:55 pm

Re: actual devices are not shown in mapping menu

Post by pooriyasms »

thank you very much leo
I will try it in the site next week and I'll tell you the consequence.
Post Reply