Ground Fault

Post Reply
JR75
Posts: 2
Joined: Wed May 28, 2014 6:24 pm

Ground Fault

Post by JR75 »

Just recently upgraded from the IRC-3 to the EST-3 and Fireworks system so still trying to find my way around it. One of the buildings has 2 ground faults. I have these in the past and they have been hard to find. But, on the Fireworks I looked at the Alarm Points and its giving me these codes for the ground faults.


01-01(01-007-01000602)

01-04(01-007-01020677)

Can anyone tell me what these codes are for? I suspect the last set of numbers are the panel/card/port but I was hoping that the rest of it would give me some direction on where to look instead of simply digging for days upon days.

Thanks for any help.
Sam
Posts: 29
Joined: Sun Oct 17, 2010 6:38 pm

Re: Ground Fault

Post by Sam »

01000602 Power Supply
01020677 first module after power supply.
JR75
Posts: 2
Joined: Wed May 28, 2014 6:24 pm

Re: Ground Fault

Post by JR75 »

Sam wrote:01000602 Power Supply
01020677 first module after power supply.
Sam,

Thanks for the reply. I suspected this, but wasn't sure with the 01-01 in front of them. Any hints as to what could possibly be causing a ground fault for both of these, power supply and module?
Sam
Posts: 29
Joined: Sun Oct 17, 2010 6:38 pm

Re: Ground Fault

Post by Sam »

01-01 is add by FireWorks.
For power supply or cpu if you remove RS232 for Fireworks, ground go off for 01000602.
01020677 which module ?
Post Reply