PXNplus CPU board - manuals, problems

Post Reply
Leo
Site Admin
Posts: 886
Joined: Thu Dec 11, 2008 7:52 am

PXNplus CPU board - manuals, problems

Post by Leo »

The PXNplus replaces the PXN CPU board

http://www.gesecurity.com/portal/site/G ... &seriesID=
Attachments
PXNplus CPU Board Firmware.pdf
(92.76 KiB) Downloaded 590 times
PXNplus CPU Board release notes.pdf
(277.03 KiB) Downloaded 632 times
PXNplus FAQ.pdf
(304.01 KiB) Downloaded 724 times
Leo
Site Admin
Posts: 886
Joined: Thu Dec 11, 2008 7:52 am

PXNplus CPU board - problems (working on)

Post by Leo »

I had a board that was in OS maintenance mode and would not come out.
I called tech support, who said I needed to replace it.

OS (Operating system) maintenance mode - Alternates DS2/DS3, On DS7



((( you will not be able to web into the card if this switches are not set ))
Set dip switch SW5-6 to OFF.
Set dip switch SW5-7 to OFF.
vtzram
Posts: 7
Joined: Fri Oct 29, 2010 1:34 pm

Re: PXNplus CPU board - manuals, problems

Post by vtzram »

evein i faced the same problem at one of site.I have shorted the jumper and reboted the card and also in integrated configuration tool i have selected picture perfect and after restart of PXN plus card and again changed it to secure perfect and it worked.
I don't know above two which worked out but my all the three controllers worked fine there after.
Post Reply