MIRTONE MODEL QUICKSTART

Post Reply
delanil
Posts: 20
Joined: Mon Jan 04, 2010 8:11 pm

MIRTONE MODEL QUICKSTART

Post by delanil »

hI ALL,

I have a panel , which is Mirtone make Quickstart . I have used EST QS-CU software but it does not communicate.

So , I have replaced CPU ,now its communicating with CPU . But Smoke detectors also is EST-Mirtone Type. So I get trouble for all detectors . Detectors are working fine on smoke test, Hooter are also activated . But it shows traouble afor all the detectors.

Some one Pls Help to sort out this problem.

regards
FVILLA
Posts: 137
Joined: Tue Oct 13, 2009 3:41 pm

Re: MIRTONE MODEL QUICKSTART

Post by FVILLA »

hi, you need to put back the older cpu an used the mirtone Quickstart software MIRQS-CU.

regards...
delanil
Posts: 20
Joined: Mon Jan 04, 2010 8:11 pm

Re: MIRTONE MODEL QUICKSTART

Post by delanil »

Older Mirtone CPU is fail aow i have to use this QS4 CPU only.

Currently i am getting alarms if testing any detector . But i don get any troubles for open/ short in loop.
Freaky76er
Posts: 5
Joined: Fri Apr 16, 2010 9:14 am
Location: The Wild West

Re: MIRTONE MODEL QUICKSTART

Post by Freaky76er »

mirtone quickstart = Mirtone devices

est quickstart = Est devices

had a Mirtone cpu Panel fail 8 months ago, tried to swap with EST QS CPU, ended up replacing all smoke detectors due to non-compatibility
Leo
Site Admin
Posts: 886
Joined: Thu Dec 11, 2008 7:52 am

Re: MIRTONE MODEL QUICKSTART

Post by Leo »

per EST tech support the smokes are NOT compatible, but the modules are compatible .
Post Reply