TheAlarmTech.com

It is currently Sun Jan 21, 2018 11:26 pm

All times are UTC - 5 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Thu Dec 28, 2017 2:45 pm 

Joined: Thu Dec 28, 2017 2:41 pm
Posts: 1
Good afternoon

I have a mapping failure problem in the EST3 central. There was no change in the loop, nor devices, only removal of some detectors for cleaning. The problem is that mapping failed and after downloading the program to central, the mapping did not complete (stops at device 50, total of 104). When uploading the mapping, nothing appears. I already tried to perform reinitialize loop, dowloaded again, but had the same result.


Top
 Profile  
Reply with quote  
PostPosted: Sun Dec 31, 2017 11:36 am 
Site Admin

Joined: Thu Dec 11, 2008 7:52 am
Posts: 742
most likely one of the smokes you cleaned is not sit right.
I would remove ALL the smokes you cleaned check the base, look for anything that does not look right
and put back.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group