Fireworks and EST3 connection

Post Reply
Ren
Posts: 5
Joined: Wed May 15, 2019 1:18 pm

Fireworks and EST3 connection

Post by Ren »

Hi to everyone.

If possible I would like some help of you guys.

I am using the FireWorks v1.71 and I am trying to connect with an EST-3 panel through the Edwards MN-COM1S but no matter what I do I can't establish connection. Port 1 of EST-3 is on 19200 Gateway III just like the FireWorks, MN-COM1S is also on 19200 but still no connection. Red cable of MN-COM1S is on Rx, black on Tx and green on COM of EST-3 but the EST-3 still keep with the "Aux Port 1" trouble. I read something on this same forum about the equipment MN-NETSW1, it says the MN-COM1S only works with the MN-NETSW1, is that true?

Someone could help me please?

Thanks in advance.
Post Reply