Honeywell NetAXS - Exit buttons stop responding

Winpak-PE/SE , NStar, N1000, PW2000
Post Reply
turbotim
Posts: 1
Joined: Fri Feb 16, 2018 6:49 pm

Honeywell NetAXS - Exit buttons stop responding

Post by turbotim »

Hi Guys,
Has anyone experienced the exit buttons on a Honeywell NetAXS 4S or NetAXS 123 stop responding and a power reset is required to get them functioning again.

During the fault, the card readers still work correctly. This happens across all versions of firware from the very oldest to the very latest. All the cables are shielded.

Tried all the Honeywell recommendations, S4 supressors, earthing the cable screens, e.t.c.

This is happening across around 30 or so panels on various sites, just wondering if we're the only ones experiencing this.

Thanks
mattiescott80
Posts: 1
Joined: Wed Mar 06, 2024 2:16 am

Re: Honeywell NetAXS - Exit buttons stop responding

Post by mattiescott80 »

Hi

I am having the same issue on a similar scale... Did you ever get a resolve??

Thanks
Post Reply