TheAlarmTech.com

when there is wiring problems you will get "Mapping pending" and it will not go away. open the SLC loop so there is only a few devices and see if the Mapping pending problem goes away. if so add devices until you find the problem, loose smoke head, maybe the feed to a base is miss wired. ...

Dear all,
any one can help me please to write a typical rule for a siga-ct2 ?;so that when a door closed ,an audible device go to alarm.
many thanks.

Hi Leo,
not only leds,I want a status panel that could change the system to auto/manual/inhibit by switch ,like status panels that Kentec company produce for its extinguishing system.
thanks again.

Hi to all,
I writ below rule, but the release outputs dont work when 'and_group1' activate:

[Test Release]
Alarm 'and_group1':
on 'flasher_1',
DLYA 30,
on sup 'release_1';

the wiring and labeling are true.
any suggestion please?
many thanks.

Hi everybody, I am working on an EST-3/cab5 system,I have connected an audible device to free contact alarm relay of 3CPU-3 card of panel,know when an alarm appearance in the system(for example when a smoke detector detects fire) the audible device go to alarm and I can not turn off it by the "...

Hi everybody, I am looking for a status panel that provide me the states of panel(enable/disable, Released conditions,fault and fire in system.and disabling the system by a switch). My fire alarm panel is EST3 ,also I have extinguishing system(FM200) that activate by siga-rel module. Any Suggestions...

Hi everybody, I installed RS232 card in J2 slot on CPU card of a EST3 panel and I want to communicate fireworks to panel.also I set port 1 on SDU In Gateway-iii/boudrate 9200 and same setting on system builder. I have a problem with auxiliary port(auxiliary port1 fault on LCD), and communication fau...

Hi everybody
Im working on EST3 Panels programing,after download the program to panel I see below status logs :
1. line fault, loop 1
2. Mapping pending, loop1
3. Sensor Initialization ,Loop 1
4. Unprogrammed Trouble ,Loop 1
any one can help me please?

thanks again "Leo"

Hi everybody,
after have been downloaded code,database and bootstrap on an EST3 panel i see below fault message on LCD card:
1. database out of sync with cpu
2. unprogrammed device data card
3. auxiliary data card
any one can help me please to solve these fault?
many thanks.