TheAlarmTech.com

Hi Peter -check that the 3-RS232 optional card is installed correctly -check the proper configuration to port1 port2 in SDU. regards... Hello I would like connect printer to est-3. I try connection based on manual from printer est pt-1 but printer not working. What is proper connection and setup of ...

hi, hope this is what your looking for. regards... EST3 - 3-CPU3 Boot Code Version Introduction New 3-CPU3 modules are being shipped from the factory with application and boot code version 3.70. This may result in a 3-SDU mismatch message. Issue 3-SDU version 3.72 includes only 3-CPU3 boot code vers...

hi, other option is that you do the honeywell xls1000 certification theres no need to be ''strategic partner'' and then request a software key to GE tech support with yours honeywell certification.
you can contact GE with this scenario, i do this but inverse and i have both keys.

regards.

Hi, i have the same problem, i put an isolator base in the first detector from the main loop.
with that you may prevent damage to the circuits and the panel wont be crazy.

regards...

hi, you need to put back the older cpu an used the mirtone Quickstart software MIRQS-CU.

regards...

Hi, also the certification is basic the same as the GE EST3, but the software and key is different. see the mail from tech support: Hello, I’m not familiar with the EST3 Certification, but I think the basic content is the same. The main idea is to gain some experience using the SDU by programming an...

hi these are the steps i do when i powerdown any fire panel:

-discconect battery
-turn off the main braker

for power on

-connect battery
-turn on main braker

just a tip

regards...

Hi forumities, Some times, when there is a troubles on EST3 panel caused by a detector, I open the detector from base, clean it and re-install in again and reset the panel and the troubles is removed. But some times the troubles is not removed, so I disconnect Battery & AC power and turn the pa...