TheAlarmTech.com

try downloading using a lower baud rates like 9600 from both RJ-11 and serial port

Having one AND-Group for smokes and another for pulls with activation of 2, how do 1 smoke alarm and 1 pull alarm activate EVAC? I suggest using logical output as follows: { Create a logical output "EVAC_LOUT" turn it OFF on startup = bring counter to -1 any alarm - smoke or pull - will ad...

Do you want any smoke AND any station, or do both have to be on the same level before activating EVAC?

FranckGlobe wrote:Hi,
Someone can help me with that code please
2B2099D

Thank you

51130

The built-in editor that the SDU uses is very limited and is unable to open large files.
go to Options/Customize choose the configuration tab and at the bottom uncheck "Use Default Editor" and select a different rule editor, i.e. Notepad, Notepad++ etc.

According to my decode sheet
2B23BA7 decodes to 51770
0880888 decodes to 11111
hope it helps

try this code : 10986

There is really not much to do other than activate the address. From installation sheet: "Activating the primary (first) address selects the signal on channel 1. Activating both addresses selects the signal on channel 2." ON -LOW AUD 'Your_Label_Here', You should however have an audio sour...

CT1's do not have individual pseudo points!
what is the exact message and details you're getting?

Configure an AND-Group for each valve tamper and make it a supervisory event with no members. Untested! [VALVE TAMPER ACTIVATION] SUPERVISORY TAMPER 'TAMPER_<n:1-10>': STEADY '*LED_TAMPER<n>', -ACTIVATE AND 'RESTORE_TAMPER_<n>'; {note: this line executes on restoral} [VALVE TAMPER ACKNOWLEDGE] ACK T...