TheAlarmTech.com

Replace the LCM, loop control module.

I have seen that before and all I can say is good luck if the cpu is an older one...They updated the card with new firmware and unless you have matching firmware in the loop controllers you will see mismatch errors.


Good luck

The software requires a security usb dongle and will not open without.

Post a copy...

I haven't used service groups but we use switches all the time to disable A/V's. Program the general alarm output group to activate all your CC1's as a Priority Low. Program a switch as toggle then assign an output group to it. Then program that output group to Restore your CC1's Priority High. We a...

Tried all sorts of stuff Reset: ON LED_1 ON Reset_rly_ +Delay 02 OFF Reset_rly_ R1: +Delay 02 ON LED_2 R2: +Delay 02 ON LED_3 R3: +Delay 02 ON LED_4 I programmed some extra LED to track how the delaying works, and watched my Reset_rly_ with a meter. The delay as shown above works fine. Proves what I...

We tried a couple of things with no success...The following did not work R1: Delay 02 ON Reset_Relay_ Delay 02 OFF Reset_Relay_ Also tried adding resetcab at the end of that which failed also. It does appear that R1 is ignoring the "Delay" command. From what I can tell during my experiment...

So how many of you have had the "reboot Fail" problems with your QS v1.8 panels? In the past 2-3 years I've seen a 60% fail rate on them. We have to replace the cpu when this happens, tried reprogramming but that only seems to hold for a couple days.

Sorry for the delay but haven't had time to make it over there to test anything...I will keep u informed..

I have a CT1 monitoring another piece of conventional alarm equipment that is being reset via a CR. Problem is that the EST3 panel is finished resetting before the equipment restores the CT1 state to normal (2-3 seconds). We have to reset twice to clear the EST3. The CR is turning on via the R1 rule...